Logo Bevel

Cooling System Installation in Race Car

Cooling system installation for your race car.

I just finished installing a cooling system for in between rounds to cool the car off in 10-15 minutes, instead of dropping all the water on the ground or on into a container. So we’re going to try it out here in a little while to see how it works, but I installed some jiffy tight fittings, and went in back here with the T assembly. As you can see, close across to the opposite side, so I can push the water from the bottom of the engine up to the highest point up here in the neck through a pumping system for this engine to cool it off as quickly as possible from in between rounds.

I hope you enjoyed this quick video on after the cooling system installation was done.

Here are a couple more installation articles that might interest you. If you’re interested in adding services to your business, then check out Parts and Installation. For installing parachutes, take a look at  Parachute Installation.